1. Knowledge Base
  2. Webinars
  3. Webinar Settings and Administration


Give attendees and presenters an optional audio choice when presenting or listening to webinars: Dial-In audio

Note: You MUST enable Dial-In in order for attendees to dial-in to the event.

Under your webinar's Edit section, click to the Dial-In section and check off Yes, allow attendees to dial-in to allow attendees to use Dial-in. You can enable them to speak through Dial-in, as well as access the Presenter Dial-in information. 


Screen Shot 2022-10-17 at 11.59.00 AM


BigMarker provides two ways to use Dial-in : 

  1. Dial-in for ATTENDEES is default listen only and available only if enabled by host. This number is available after registration. You can allow attendees to speak through dial-in by enabling this in your webinar's settings (pictured above). 
  2. Dial-in for PRESENTERS is two-way (can listen and talk) and recommended for those who have slow internet connections or poor audio on their computers. 

Dial-in numbers and codes for attendees can be found on the webinar landing page, the registration confirmation page, and reminder emails. These numbers are only available if the host has enabled this option and the person is registered for the webinar.

Dial-in numbers and codes for presenters must be shared with all the guest presenters by the webinar admin. The number is located within the Edit section of the webinar. This number should not be shared with attendees. Presenter dial-in is always enabled. 

Webinar Page before registering: 

Screen Shot 2022-10-17 at 12.08.31 PM

Webinar Page after registering: 

Screen Shot 2022-10-17 at 12.09.07 PM


Confirmation page after registering:

Screen Shot 2022-10-17 at 12.08.56 PM


Confirmation Email: 

Screen Shot 2022-10-17 at 12.05.20 PM


Dial-in for Presenters must be shared by the webinar Admin and is listed within the webinar details of the Edit section:


Screen Shot 2022-10-17 at 11.59.00 AM